BUNKER

Introduction

BUNKER is designed as a multi-purpose tracked chassis with different application scenarios considered: simple and sensitive operation, large development space, adapt to various fields of development and application, independent suspension system, high payload and suspension, strong climbing ability, can climb stairs. It can be used for the development of special robots such as inspection and exploration, rescue and detonation, special shooting, special transportation, etc., to solve the robot mobile solution.

Package List

1 * BUNKER
1 * Battery Charger, AC 220V
2 * Aviation Plug (Male, 4 Pin)
1 * USB to CAN communication module
1 * USB to RS232 Cable
1 * FS Remote Control Transmitter (Optional)
1 * Manual

Max Playloads	80kg
Max. Speed	6km/h
Dimension	1020*760*360mm
Gross Weight	135kg
Min. Turning Radius	0m
Obstacle Surmounting	17cm
Slope Climbing	35°
Max. Distance	10km

Dimension

Operation

• In remote control operation, make sure the area around is relatively spacious.
• Carry out remote control within the range of visibility.
• The maximum load of BUNKER is 80KG. When in use, ensure that the payload does not exceed 80KG.
• When installing an external extension on BUNKER, confirm the position of the center of mass of the extension and make sure it is at the center of rotation.
• When installing an external extension on BUNKER, confirm the position of the center of mass of the extension and make sure it is at the center of rotation.
• Please charge in time when the device voltage is lower than 48V.
• When BUNKER has a defect, please immediately stop using it to avoid secondary damage.
• When BUNKER has had a defect, please contact the relevant technical to deal with it, do not handle the defect by yourself.
• Always use BUNKER in the environment with the protection level requires for the equipment.
• Do not push BUNKER directly.
• When charging, make sure the ambient temperature is above 0°C.

Maintenance

• Regularly check the tension of the hanging crawler, and tighten the crawler every 150~200h.
• After every 500 hours of operation, the bolts and nuts of each part of the car body should be inspected. If they are loose, they must be tightened immediately.
• In order to ensure the storage capacity of the battery, the battery should be stored under electricity, and it should be charged regularly when not used for a long time.

Contact Us Now